SETIPOL
Single component, aliphatic, waterproofing acrylic resin
Waterproofing and elastic coating based on polymer resins and pigments, forming a completely bonded sheet on the support without joints or overlaps.
Use
For waterproofing and protection of:
- roofs, terraces, balconies, etc ...
- protection and coating of the polyurethane foam TECNOFOAM from the UV rays and others climatological agents
NOTE: call our technical department about the application to other supports or situations
consumption | ± 2 kg/m² (1,5 mm thickness) |
tack free at 23 ºC | ±1 hour |
repaint at 23 ºC | ±24 hours |
dilution | water |
application method | By brush, roll or “airless” equipment |
GENERAL FEATURES
- High elasticity of the product, more than 300%.
- Great grip and adaptability. By presenting themselves as a paste-fluid, it adapts to all surfaces with ease of application in corners and inaccessible areas. The perfect grip does not allow the flow of water below the waterproofing, located much better, breakage of the blade.
- Advantages to the continuous sheets.
- Allows the formation of a seamless continuous sheet across the surface, avoiding possible errors in the welds.
- Do not apply at temperatures below 5 ºC, or in rainy weather. Nor are applied to surfaces above 45 °C.
APPLICATION TYPES
- It can be applied by brush, roller or airless spray.
- Support properly clean (dust, moss, grease, ...),it must be dry.
- Ensure there are no detached surface parts should be removed.
- On tile and concrete shall be based on applying a first layer of product diluted with 15% water to increase the penetration and adherence of the same.
- Apply a first coat, with a consumption of about 0.750 kg/m², impregnating a glass fiber reinforcement and let dry.
- Apply a second layer with an approximate consumption of 0,750~1 kg/m². Final consumption should be 2 kg/m² so necessary a third application.
YIELD
Product yield is ± 2 kg/m² with a thickness of 1.5 mm, applied in one or various coats, depending on the application method and conditions.
PACKAGING
Metal tins of 25 kg.
SHELF LIFE
12 months at temperatures between 5°C and 35°C, provided it is stored in a dry place.
HANDLING
These safety recommendations for handling, are necessary for the implementation process as well as in the pre-and post, on exposure to the loading machinery.
- Respiratory Protection: When handling or spraying use an air-purifying respirator.
- Skin protection: Use rubber gloves, remove immediately after contamination. Wear clean body-covering. Wash thoroughly with soap and water after work and before eating, drinking or smoking.
- Eye / Face: Wear safety goggles to prevent splashing and exposure to particles in air.
- Waste: Waste generation should be avoided or minimized. Incinerate under controlled conditions in accordance with local laws and national regulations.
Anyway, consult the material and safety data sheet of the product (MSDS)
PROPERTIES
PROPERTIES |
VALUES |
Aspect |
Thixotropic and colored liquid |
Density at 23ºC ISO 1675 |
± 1,4 g/cm³ |
Viscosity at 23ºC ISO 2555 |
±30.000 cps |
Solid contents |
±64% |
Elongation at 23ºC ISO 527-3 |
>200% |
Tensile strength at 23ºC ISO 527-3 |
>0,5 MPa |
Tack free time at 23ºC | 2~4 hours |
Temperature resistance service |
-20~90 ºC |
Application temperature |
5~45 ºC |