TECNOMESH 100
Reinforcing mesh
Mesh for reinforcing of waterproofing membrane DESMOPOL at detail work or critical points and areas.
Use
To use in these kind of situations:
- To use for reinforcement at special points in the application of one component polyurethane membrane DESMOPOL. (upstands, flashpoints, internal outlets, evacuations, and fissures).
- On the polyurethane membrane Desmopol for waterproofing and coating under the following conditions: sinks zones, bars or other drainage zones, race, upstands and flashpoints in the perimeter
- Reinforced expansion joints, active cracks, insulation joints,
- Strengthening all unions and meetings between heterogeneous materials and different expansion coefficients.
NOTE: call our technical department about the application to other supports or situations
density of mesh | 100 g/m2 (±10%) |
tensile strength (mesh) | >20 N/150 mm |
tensile strength(warp thread) | >20 N/150 mm |
content binder | 6-10% |
water content | <0,4% |
fiber lenght | 50 mm. |
APPLICATION METHOD
- applies the first layer of DESMOPOL
- when it is still in the drying process wet out to embed the mesh in the membrane layer. Use a dry roll to do it.
- wait to dry
- apply the next layers of DESMOPOL needed.
- apply TECNOTOP S-3000/1C/2C/2CP, regarding the specifications
PACKAGING
Rolls of 50 m2, 1 ml of width
HANDLING
Consult the material and safety data sheet of the product. (MSDS), or contact our technical department.